Configuring Additional Parallel Ports

Configure a second parallel port (/dev/lp1) by adding the corresponding r entries to /etc/modules.conf, as shown in File 4. In this case, the default n

IO address should be set to 2 78 (hexadecimal). This may be changeable on ^ the hardware level, for example, by setting a jumper on an ISA expansion card. P

r alias parport_lowlevel parport_pc q options parport_pc io=0x3 78,0x27 8 irq=none,none

File 4: /etc/modules.conf: Two Parallel Ports

Was this article helpful?

0 0

Post a comment