Viewing Network Configuration

1: lo: <LOOPBACK,UP> mtu 16436 qdisc noqueue link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00 inet 127.0.0.1/8 brd 127.255.255.255 scope host lo inet6 ::1/128 scope host valid_lft forever preferred_lft forever 2: sit0: <NOARP> mtu 1480 qdisc noop link/sit 0.0.0.0 brd 0.0.0.0 3: eth0: <BROADCAST,MULTICAST,NOTRAILERS,UP> mtu 1500 qdisc pfifo_fast qlen 1000 link/ether 00:03:ff:69:68:12 brd ff:ff:ff:ff:ff:ff inet 192.168.0.5/24 brd 192.168.0.255 scope global eth0 i net6 fe80::203:ffff:fe69:6812/64 scope link valid_lft forever preferred_lft forever

Again, as with ifconfig, you are shown the IP address (inet) and broadcast address (brd) of the interfaces.

Was this article helpful?

0 0

Post a comment